@settings(defaultLengthUnit = in)

sketch000 = startSketchOn(XY)

sketch000Profile000 = startProfile(sketch000, at = [0.072169, 0.125])
  |> xLine(length = -0.144338)
  |> line(end = [-0.072169, -0.125])
  |> line(end = [0.072169, -0.125])
  |> xLine(length = 0.144338)
  |> line(end = [0.072169, 0.125])
  |> line(end = [-0.072169, 0.125])
  |> close()

sketch000Profile001 = circle(
  sketch000,
  center = [0, 0],
  radius = 0.0795
)

sketch000Profile000Holes = sketch000Profile000
  |> subtract2d(tool = sketch000Profile001)

extrude000 = extrude(sketch000Profile000Holes, length = 0.1875, bidirectionalLength = 0.1875)

sketch001 = startSketchOn(offsetPlane(XY, offset = 0.25))

sketch001Profile000 = circle(
  sketch001,
  center = [0, 0],
  radius = 0.0945
)

sketch002 = startSketchOn(offsetPlane(XY, offset = 0.1))

sketch002Profile000 = circle(
  sketch002,
  center = [0, 0],
  radius = 0.08
)

draftCut000Extrude = loft([sketch002Profile000, sketch001Profile000])

draftCut000 = subtract(extrude000, tools = draftCut000Extrude)