@settings(defaultLengthUnit = in)

sketch002 = startSketchOn(XY)

sketch002Profile001 = startProfile(sketch002, at = [-0.503704, -0.264924])
  |> line(end = [-0.191884, 0.172584])
  |> arc(
       angleStart = 228.031232,
       angleEnd = 105,
       radius = 0.16425
     )
  |> line(end = [0.464817, 0.124547])
  |> arc(
       angleStart = 105,
       angleEnd = 75,
       radius = 0.6315
     )
  |> line(end = [0.464817, -0.124547])
  |> arc(
       angleStart = 75,
       angleEnd = -37.055012,
       radius = 0.16425
     )
  |> line(end = [-0.200323, -0.265308])
  |> scale(x = 0.958, y = 0.958)

plane000 = {
  origin = [-0.503704, -0.264924, 0],
  xAxis = [0.191884, 0.172584, 0],
  yAxis = [0, 0, 1],
  zAxis = [-0.191884, 0.172584, 0]
}

sketch001 = startSketchOn(plane000)

sketch001Profile000 = circle(
  sketch001,
  center = [0, 0],
  radius = 0.0495
)

sweepExtrude000 = sweep(
  sketch001Profile000,
  path = sketch002Profile001
)

plane001 = {
  origin = [-0.503704, -0.28, 0],
  xAxis = [-0.191884, 0.172584, 0],
  yAxis = [0, 0, -1],
  zAxis = [-0.191884, 0.172584, 0]
}

sketch003 = startSketchOn(plane001)

sketch003Profile000 = startProfile(sketch003, at = [0, -0.06])
  |> line(end = [0.129019, 0.12])
  |> xLine(length = -0.129019)
  |> yLine(length = -0.12)
  |> close()

cut000Extrude = extrude([sketch003Profile000], length = -0.2)

cut000 = subtract(sweepExtrude000, tools = cut000Extrude)

plane002 = {
  origin = [0.42, -0.28, 0],
  xAxis = [-0.200323, -0.265308, 0],
  yAxis = [0, 0, 1],
  zAxis = [0.200323, 0.265308, 0]
}

sketch004 = startSketchOn(plane002)

sketch004Profile000 = startProfile(sketch004, at = [0, -0.06])
  |> yLine(length = 0.12)
  |> xLine(length = -0.129019)
  |> line(end = [0.129019, -0.12])
  |> close()

cut001Extrude = extrude([sketch004Profile000], length = -0.2)

cut001 = subtract(cut000, tools = cut001Extrude)